Challenge
Drag the tool along the seam. Switch the correction module on and off while you move – the hand motion stays the same, only the tool changes.
Challenge
Seam finished
humanoid only with the module
- Your run
- –
- Humanoid only
- –
- With correction module
- –
- Target
- –
Deviation0.00 mm
1 mm target
05 mm
Press and hold on the start dot, then follow the line · M = module, R = restart
Simulation, not measured data.
How to play
Press and hold while drawing — releasing stops the run.
- Press on the orange dot, keep holding, and follow the seam to the end.
- Switch the correction module on and off while you move (button or M).
- Stay inside 1 mm – the deviation is shown live.